It is not recommended to use the RJ-50 connector by itself to perform a loopback test due to the small separation between pins. If you use a RJ-50 to DB-9 serial cable (Part Number 182845-XX), a loopback test can be performed using the pins for a DB-9 connector. The positive connections are indicated in red, the negative connections are indicated in blue, and the GND connections are indicated in green. Refer to the pins below based on your connector type.
RS-422/485) and the type of serial connector you have. Identify what serial communication protocol you are using (RS-232 vs.
Refer to the sections below to properly connect your hardware.